Temperature and humidity chamber test key customer of goods resistance to climate resilience, simulation high temperature, ultra-low temperature, high temperature and low temperature and cryogenic temperature drying and other extreme climate Ziranhuanjing, and then assess the product's credibility and its product development time Shortcomings. Is to enhance the competitive edge of goods necessary test equipment used in metal parts, plastics, electronics, small toys, lighting, LED, board interfaces, the integration of these manufacturing industries, is your manufacturing, product development, quality control idealized experiment device.
In peacetime use of the whole process, some customers because the use is not very skilled, sometimes resulting in temperature and humidity chamber to generate boot down the conditions for this kind of situation Elton carry out a detailed analysis, look forward to for the majority of the masses FAQ.
1, if such a thing is generated, checked one by one, only the first temperature setting device (40 ° C or 60 ° C), the humidity is set to 0, operation of the tap, will not see the device is tripped, the heating pipe is short-circuited malfunction, causing electric shock, temperature and humidity chamber will maintain multifaceted situation will have to jump electricity. If this short-circuit failure heat pipe, the heat pipe can be as long as a change, the actual operation is relatively simple.
2, if the operating temperature is not tripping, set humidity, then tap operation, temperature and humidity chamber to see if the trip again. If the trip was a humidifier tube short-circuit fault, go electric. If the six produce such cases, only the side of the separator device factory screw down, taking out the spacers, will see a humidifier tub, the two lines deprived of its upper side, the outer cover hex bolts removed, the tube will be able to replace the humidifier, the time necessary to install the temperature sensor associated with the camera on the humidifier, the avoidance of air burning, overheating maintenance.