https://blog.csdn.net/u014552102/article/details/86700057
First, the mobile client operations:
first, fluorite mall official website https://www.ys7.com/ download "fluorite cloud video" mobile phone client to install. After installation is complete, the client is opened, the phone operates as a step by step according to the official end of the camera operating instructions shown here :( wifi router must be connected to the phone and to ensure that the phone and camera connected to the same wifi environment, and because using sound waves is connected wifi, in this process, the camera is not connected to the network cable. Add the following configuration and operations must be completed within 3 minutes after power to the camera, otherwise it would re-rebooting the camera operation)
And an antenna plug camera power supply, camera start, fluorite client dimensional code scanning camera body:
After scanning the two-dimensional code, because bloggers device over the network has been configured, the interface appears as follows, to obtain the RESET key press device, reset the device.
Enter the phone in the following figure connected wifi name and password, click "Next." (Where the password was entered correctly, if not correct, there will be no prompt, but the next step is "sonically configure the network" will fail)
The phone volume to maximum, the speaker phone close to the camera and microphone position, click "send sound waves" in wifi configuration.
When the screen appears following figure shows the configuration wifi success.
Then we can phone the client real-time view of the camera video screen
Second, the PC client operations
after the completion of the mobile client operations, we fluorite cloud video https://service.ys7.com/download official website to download the client computer. Once downloaded open the client computer, log on, and then in the "Device Manager" and "Network Setting" here to get IP address of the camera (you can see from the figure below bloggers camera ip address is 192.168.1.105, the address of each once after Reset and reboot the camera are changes that may occur. Remember this address, the development was
used) ----------------
Third, the browser operation
will also be connected to the same computer with the camera's wifi network (this address can be obtained from the second step of the client PC operating ip address 192.168.1.105 in the browser address bar enter the camera. Here very the pit is the official description says Kang initialize the camera's ip address is 192.168.1.64, but after the mobile client operation is in progress, the ip address changed, but the instructions did not mention this in the browser and then 192.168.1.64 is it not get logged in, and have to get to the new address p in the computer client, it is very pit).
FIG next input account number and password. Which account admin, and the initial password is admin + camera body verification code (to note here is that there's account and password is the camera itself, account number and password, not the mobile client and PC client account and password, and if by after the camera body RESET button to restore the factory settings, here's account and password will change, but the client's account and password will not change. so do not confuse the two).
After logging in, we can see some of the configuration parameters of the camera and video camera in the browser.
