Trunk Configuration Experimental Details

Trunk Overview
"trunk" is generally translated in network parlance: "trunk, trunk, long-distance lines," but generally do not have Italian translation, direct English. Routing / switching network, trunk commonly referred to as a "relay (pass-through)." In applications in voice-grade line, generally refers Trunk circuit connection or channel between the "backbone network telephone trunk", i.e., two or exchange switch for switching it between two devices, and a signaling terminal data transmission link device.

Trunk Configuration Lab

Step 1: Pull into the operating area of ​​GNS3 two switches and four PC.
Trunk Configuration Lab

Step two: two switches then performed in the same hardware configuration.
Trunk Configuration Lab
Trunk Configuration Lab

Step Three: Next we need to interface and IP address of the PC and switch to plan.
Trunk Configuration Lab

Step four: to configure the device against the plan. Here we first entered the global schema canceled routing function of the switch, then we configure the switch sw1 of two interfaces, interface f1 / 0 configured vlan10, the interface f1 / 1 configured as vlan20, and finally remember to check the configuration.
Trunk Configuration Lab

Next, the switch sw1 sw2 carried out as the same configurations.
Trunk Configuration Lab

Here we first sw1 interface f1 / 2 and f1 / 3 were trunk configuration, the configuration is complete remember to check the configuration.
Trunk Configuration Lab
Trunk Configuration Lab

Sw1 and sw2 for the same operating configuration.
Trunk Configuration Lab
Trunk Configuration Lab

Here are four of the IP address of the PC to set up.
Trunk Configuration Lab
Trunk Configuration Lab
Trunk Configuration Lab
Trunk Configuration Lab

The following four between PC, stitching, experimental results show that the same can be between only the same VLAN. The trunk can also be described by all data vlan.
Trunk Configuration Lab

Then we will strapping together two trunk link, the first two switches tied f1 / 2 and f1 /. 3 two interfaces.
Trunk Configuration Lab
Trunk Configuration Lab

After then disconnected while the two switches f1 / 2 interface.
Trunk Configuration Lab
Trunk Configuration Lab

Then during the test interconnection between two identical vlan, results show a case where a two trunk link is disconnected for some reason does not affect the normal communication between devices.
Trunk Configuration Lab

The experiment proved that we can be across multiple vlan switch only communicate via a link. It also shows the interface including Ethernet channel if there is a trunk accidentally disconnected and will not affect the normal communication between our two facilities in the trunk.

Guess you like

Origin www.linuxidc.com/Linux/2019-08/160379.htm