Three-tier exchange - experimental articles

Three-tier exchange - experimental articles

First it is still open GNS3, follow the steps before we learn to configure routing and PC, as shown:

Now, we start configuring the PC and routing environment, with a network cable to connect them together, click the button display port, and is turned on. Figure:

Double-click to open the sw1, began deployment environment for the route, as shown:

After the completion of the previous step, start Trunk configuration settings must check after each step is complete configuration setup is complete, to avoid making mistakes, as shown:

SW1 has been completed then the time configured, you can sw2 environment, IP addresses and Trunk, as shown:

After settings are done, the next it is to witness the miracle of the moment! First set the IP address for the PC123. Figure:

At this point the configuration is complete, open the PC1 to ping other PC, it can interoperability, then the experiment proves successful! Figure:

Test success!