Linux installation and Networking

First, the experimental environment: VMware14.0.0
Second, install version: CentOS-7.4
Third, the installation steps:
1, open VMware14, create a new virtual machine.

2, select Custom and click Next.

3, the steps of any changes, just click Next.

4, choose to install the operating system later.

5. Select the system for Linux.

6, the virtual machine name and select the storage location, pay attention to the path of the storage location must not appear in Chinese.

7. The personal computer memory to configure the number of processors and the number of processor cores.

8. The computer memory configuration settings of virtual machines.

9, the network connection chosen NAT mode.

10, this step keep the default unchanged.

11, this step is also to keep the default.

12, choose to create a new virtual disk.

13, the disk space is set to 40G, and choose to split the virtual disk into multiple files.

14, the virtual machine disk files in the storage path.

15, click the following custom hardware to optimize.

16, less than the removal of the sound card and the printer.

17, select the CD / DVD, and image files into the drive.

18, put away the image, click Done.

19, a virtual machine has been created, click below to open the virtual machine.

20, where the up and down keys on a personal computer using the cursor and select Install Centos7, and then press ENTER and wait for the system installation.

21, select Chinese and continue.

22, select the software to select the setting.

23, choose the GNOME desktop then click Done.

24, select the installation location into the zoning plan.

25, I want to select the configuration partition and click Done.

26, open the drop-down menu and select standard partitions.

27, click the bottom left of the + to add a mount point.

28, the open market option to select /, then set a desired capacity of 20G.

29, the same method of setting the mount point and capacity swap, swap is when the system's physical memory is not enough, a portion of the physical memory space is released, for the use of the currently running program.

30, and then boot mount point add in, boot is a storage system.

31, finally home mount point is also added to it, the user's home is located, except administrator.

32, after all set up mount points Click Finish.

33, then prompt box will pop up, here choose to accept the changes.

34, following selection to begin the installation.

35, will be installed at the root administrator password, you set it.

36, installed after the restart click.

37, where some going to choose to accept the license.

38, after receiving the license, click to complete the configuration.

39, where Chinese continue to choose.

40, input selection here too Chinese.

41, click here to continue to move forward down.

42, the time zone is set to the time zone of Shanghai.

43, if there is no account just click skip.

44, set up a user name here.

45, setting the user's login password.

46, below click on it to start using Linux.

47, turn off the Welcome screen into the system.

48, log off the current account.

49, click to select is not listed.

50, replacing the root administrator account to log on.

51, a blank area and right-click to open the terminal.

52, input vim (space) / etc / sysconfig / network- scripts / ifcfg-ens33 in the terminal and the card is set to the transport state.

53, a personal computer using a direction key to move the cursor no, the key press I insert mode.

54, no change will be yes.

55, press Esc to exit classified mode, enter ": wq" to save and exit.

56, entered service (space) network (blank) restart to restart the network services.

57, which appeared to open the network services.

58, open the application of the Firefox browser.

59, enter the URL to the Internet.

Linux is now installed here and be able to get online.