Three switches experiment

First, the experimental environment; GNS3-1.3.10
Second, the purpose of the experiment: to achieve interoperability through the three-tier exchange different VLAN.
Third, the experimental steps:
1. Open GNS3, dragging two routers to your workspace.

2, two VPC again and again to the workspace.

3. Right-click the icon to open the Router tab, the names are changed to SW1 and SW2.

4, the SW1 128MiB the memory.

5, SW1 to add a two-story business card.

6, SW2 to set the memory to 128MiB.

7, the switch SW1 icons into icon.

8, will be replaced by three switches SW2 icon icon.

9, using a network cable goes around together.

10, planning a PC IP address, range and vlan vlan Gateway.

11, click Turn on the devices.

12, the input of SW1 tab of the conf (space) t into the overall pattern, and then enter the no (space) IP (spaces) routing off routing function.

13, enter the vlan (space) 10, 20 to create two vlan.

14, input int (space) f1 / 1 enters the port mode, input sw (space) Mo (spaces) into the ACC access link, then the input sw (space) ACC (space) VLAN (spaces) 10 1/1 port included vlan10.

15, as in the above 1/2 opened included vlan20, and then view vlan information.

16, entering 1/0 port mode, input sw (space) Mo (spaces) t 1/0 port of the trunk link link set, and then enter sw (space) t (spaces) EN (spaces) dot tie given 8.2.1qVLAN identity.

17, check to see if the link is set to 1/0 of the trunk link.

18, in SW2 1/0 option card will open the link set to trunk link, and bind 802.1qVLAN identity.

19, vlan10 enter the virtual gateway interface binding, and open interfaces.

20, the same binding vlan20 gateway and open interfaces.

21, PC1 open tabs, configure the IP address and gateway.

22, PC2 open tabs, configure the IP address and gateway.

23, enter the IP address ping PC2 with a PC, you can see the feedback from the PC2.

The experiment here was a success, thanks to reading!