Let's start to install about GNS3 and specifically how to configure it, my system is Windows10, first opening the package.
Direct the next step.
It should be noted here that, do not check the Wireshark packet capture such a tool, because it is the default download from the Internet, more slowly. So there are ready-made installation package, so no check Wireshark such an option, then the next step.
The default path is C drive below, this can vary depending on their preferences can also be installed in another letter, I chose the default installation C drive, click Next.
Because to be a packet capture tool will be installed so no, just click Cancel.
This is the boot is automatically run option, hook and no hook on personal preference, click Next.
Do not check here, is to let you spend $ 200 get a certificate of such a meaning, click to complete our GNS3 has been installed, we are going to install a software package to fetch data of Wireshark.
Man of few words said, directly to the next step.
The upper half according to their preferences, optional is optional, but the following must hook up, because the software is some configuration files.
Usually choose the default path, the path can not have Chinese. If you change the path, then later also you need to change the settings, because too much trouble here, choose the default path of the C drive, click Next.
、
Click here to remove the check mark next.
Then installation is complete.
This is a GNS3 interface, we first need to do is to give it to add a router simulation of an image file, as follows.
Do not pay attention to appearance Chinese path.
Because this software defaults are more occupied CPU, you have to try an optimization, use ldle-PC can calculate a comparison value of this software is compatible with the CPU, if the "Digital + *" then appears is the closest, if not choose the lowest of.
Our simple capture software with GNS3 has been Bahrain, and simple configuration.