In some cases, the system may need to completely cover the fan control and use custom algorithms. By covering the power and functionality combined with Auto Boost System rules, you can use TG Pro. Remember, when the fan mode is set to Auto Boost, which will completely replace the system fan control. If the fan speed is set too low, the system will not increase or decrease fan speed, thereby causing overheating Mac. While this may be a very powerful feature, but use at your own risk.
TG Pro Tutorial
To set this up, first of all for the fans to enable coverage system functions. According to Mac model you have, it will be as follows:
For 2018 and 2019 models of the Mac (with the T2 chip)
It applies to all other Mac models
TG Pro is now completely covered by the system, you must add Auto Boost rule to increase with increasing temperature and fan speed. This "automatic multiple reinforcing Rules' is very similar, but there must be a rule from 0 to 100% of the maximum start speed (note: the minimum speed is 0%). Otherwise, the fan will never be able to increase the maximum speed, which requires very high temperatures.
The following is an example set of rules:
Fan speed is always at least 10%
if the temperature is higher than any of the sensors 40 ° C,
the fan speed will be 25% if the temperature is higher than any of the sensors 50 ° C, the fan speed will be 50%?
Fan speed If any of the sensors 75% higher than 60 ℃
If any of the sensors is higher than 70 ℃, the fan speed will be 100%
Rules may be different, depending on the Mac is running on battery or plugged into a power
To enable this feature, change the fan control mode to Auto Boost , TG Auto Boost Pro will be based on the current rules of the power of the fan speed is adjusted to precisely how to set up!
These are the methods of using TG Pro custom function control system completely covered, or emphasize While this may be a very powerful feature, but use at your own risk!