We said before through the use of Chinese cabbage to make a boot disk, the system to go home to download system. Although the system can be installed, but sometimes installing a ghost version, easy to install, just behind the guide is to wait for the automatic installation, drivers do not have control of anything. But sometimes it brings a lot of software, and even clean up bad uninstall can not, because I had this computer is consuming particularly fast. So this is mainly to talk about pure version of the system installed.
A. Make a boot disk
Recommended USM, official address: http://www.usbrun.com/, pure version of the system image on hold, and if needed can follow the following message to the public No. I can do this or to windows8.1 example .
II. Began to reload
1. Restart the computer, install the F12, F11 and so on, I'm Samsung is the F12, wait screen appears when the quick start or BIOS settings, select "Innostor innostor 10.0.0"
2 into the PE interface, similar to select "windows 10PE-64-bit reduced Edition (used for maintenance)," and the like, according to their own choice computers, into the below.
3. Then open the "partitioning tool," if Bahrain is just about the machines on the first sub-region, reinstall it back up the system after-hours format.
4. Select current right-format the hard disk system, click on the "hard" -> "rebuild the master boot" -> "Clear reserved sector."
5. Close the partitioning tool to re-open My Computer, select the U disk, find the location of a pure version of the system.
6. Locate the pure version of the system image, right-click "virtual disk loading is InDisk."
7. After closing image package, download or find downloaded "winNetSetup system installer," this version of windows for other installation.
8. Open the installer to install a pop-up interface before, you first need to click the "Select windows installation source files", where (I was in front of the mirror disk package contained virtual disk place)
9. Click Install source file, a resource selection pop-up, select the "My Computer", find the "CD drive" and enter.
10. CD into the drive, select the "sources" folder, and then select "install.win", finally click Open.
11. 之后又回到了系统安装器软件的界面，下面的“引导驱动器”和“安装驱动器”,选择系统盘符就可以了。
12. 然后就点击安装就等待系统安装完毕弹出重启提示框，重启后等待电脑初启配置。
13.正常启动到桌面后，下载和找到下载好的“万能网卡驱动”，打开可以离线安装网卡驱动，就是不需要联网下，因为纯净版驱动都要安装。
14. 网卡驱动安装完毕后，可以连接wifi等再打开“万能网卡驱动”，他会自动联网扫描需要安装的驱动(显卡声卡主板等驱动程序)，然后一键安装。
15. 出现“所有设备驱动正常”，就可以关闭了。
16. 接着就需要激活系统了
17. 下载或找到下载好的windows8激活工具，比如“KMS8”等，点击“永久体验windows”，后面弹出激活成功就可以了。
三. 装机工具清单
四.待续
一些工具需要的可以关注公众号留言，后面可能再出一个GHOST版本的系统安装。
公众号
