Campus Network: The authentication program cannot continue to initialize and the solution to the problem of failure to bind the communication interface network address

This problem occurs frequently. The previous solution was: shut down and restart. This method will solve the problem nine times out of ten.

But today, I just hibernated it for a while, and then this problem occurred when I turned it on again. In the past, I only encountered it when I first turned on the computer. I didn’t want to restart, so I looked for a solution: the solutions on the Internet were to uncheck “Allow other network users to connect through this computer’s Internet”, but I tried it to no avail (and this method has been copied by countless people, I am speechless)

So I did some research and finally solved it, giving the following two solutions:

1. Restart the computer
2. In 控制面板\网络和 Internet\网络连接, find a wired connection that looks very unpleasant (ps I forgot what it is called specifically, it seems to be called xxx connection 10, which is very unpleasant to see), right-click it and disable it. The magic happens, the connection disappears directly. The campus network is logged on and the problem is solved.

Original article, reprinting is prohibited.