RoboMaster client installation and image transmission configuration tutorial

1. Install the remote control driver

Warnings may appear during installation, resulting in failure to install. At this time, use the following method to solve the problem.
Press the win key
and search for cmd
Insert image description here
to run as administrator.

Find the directory where the remote control driver file is located, right-click to view properties,
Insert image description here
enter cd on the command line...

until only the drive letter is displayed, then enter the drive letter of the remote control driver file location,
such as D:

and then enter cd D:\ElectricFiles\ STM32\RoboMaster\Operator
is followed by the directory where the corresponding file is located
. Press Enter
and then enter the file name DJI_WIN_Driver_Installer.exe
and press Enter. The installation program will run.

2. Install the image transmission driver

Image transmission receiver driver download

3. Configure the IP address of the image transmission receiver

First connect the image transmission receiver to the power supply and use a type-c data cable to connect the receiver and computer.
Insert image description here

Insert image description here
Click Network, select Network and Internet Settings.

Click Change Adapter Options

. A Remote NDIS device appears, double-click it.

Click Properties.

Double-click Internet.

Configure Protocol Version 4 as above, and click OK
. At this point, the configuration items of the image transmission receiver have been completed. .

4. Open the client and connect the image transmission receiver and the robot image transmission sender.

Operator client download

Unzip, double-click RoboMasterClient.exe,
Insert image description here

select the corresponding screen resolution and frame rate, and
click Play!

Enter client

Insert image description here
Press the P key on the keyboard

to display the settings panel
. Select the ID corresponding to the robot on the left,
such as Blue Hero Robot No. 1, then select B1 Hero

and click to log in

. If the rate appears and the screen also appears, it can be used normally. .
Press the P key again to close the settings page

If the rate does not appear, check whether the previous steps have been completed.
If the rate appears but there is no image, first unplug and unplug the power of the receiver and wait for a while. If there is still no image, check whether the system's network firewalls are all turned off.
Here is a tutorial to turn off the network firewall. Open
Insert image description here
Control Panel

. Click on System and Security

. Click on Windows Defender Firewall

. Click on Enable or turn off Windows Defender Firewall

. Select Turn off all and click Confirm to save.
This concludes the tutorial.

The copyright belongs to the author (Team Alliance). If you need to reprint or quote, please indicate the source and author. If you want to use it for other purposes or have any other questions, please contact the author of this article.