Problem Description:
two cameras,
It is no problem to connect a camera aca2500-14gm to the 100M network card of the computer motherboard, and the frame rate is 3 frames, but it will not be interrupted.
A camera aca2500-14gm is connected to the USB port (Gigabit), the pylon Viewer captures serious packet loss and the camera disconnects after a few seconds.
Solution 1: Setting jumbo frames, 1G full duplex, can not be solved (pylon Viewer takes pictures).
Solution 2: The MVS image capture prompts for packet loss verification, then change the bandwidth from 900M to 200M, and the image capture is normal at 4.5 frames.
Back to pylon Viewer at this time, I didn't find that Basler has a place to set bandwidth parameters. Compared with MVS parameters, change the packet size and delay, and solve it!
The first step is to set the bandwidth.
The second step is to check the package size automatically set by MVS.
Step 3: Set the parameters of the second step MVS into Basler,
Step 4: Save the parameters.
