Connect IPC to PC
Requirements analysis: To demonstrate the webpage software of a certain device, the industrial computer needs to be connected to the computer.
Material preparation: network cable, network cable and USB interface.
Through wired connection, the network adapter needs to be configured after checking the information.
Note: the following is the wiin10 system
to enter the network settings
Right-click to select Ethernet Properties
, change the IPv4 protocol in the network card (adapter) option, click Properties to enter, and change the name of automatically obtaining an IP address to manual setting. This is why we can simply understand this computer as a router, so the gateway below is the same as the IP above, and you don’t need to enter it.
The IP address and default gateway may be a difficult point. Here it depends on the address of the industrial computer, and the subnet mask is 24——255.255.255.0.
There are many masters who have written about the IP and default gateway settings at station C, you can refer to them.
After setting, you can connect to the login page, but at this time the network center displays "No Internet Connection", which does not affect the use.