Introduction to the interface terminology of Pad Designer pad production

• The first page
  
  1.Unit: The unit used when making the pad, usually mm or mile
  2.Decimal Place: When setting the size, the accuracy selected is to a few decimal places, usually 4 digits
  3.Multiple drill: Multi-hole setting, Generally not used
  4.Hole type: the type of drilling, usually circular
  5.Plating: whether the drilling is a metallized hole, generally choose
  6.Drill diameter: the diameter of the drilling
  7.Tolerance: the tolerance of the drilling The tolerance value is generally not set. If it is a crimping component, the corresponding hole needs to be set. The tolerance value is ±0.05mm.
  8. Offset XY: The offset value of the drill hole relative to the horizontal X-axis or Y-axis of the center of the pad.
  9.Non-standard drill: Non-standard drilling, generally not used
  10.Figure: The shape of the drill hole symbol
  11.Characters: The character identification of the drill hole symbol
  12.width: The width of the drill hole symbol
  13.Height: Drill hole The height of the hole character

• The second page
  
  1.Single layer mode: Check it for the SMD pad, if you don’t select it, it’s for direct insertion
  2.BRGIN LAYER: The starting layer of the pad, TOP layer pad
  3.DEFAULT INTERAL: The default layer of the pad, generally The inner layer of the pad
  4.END LAYER: the end layer of the pad, the
  BOTTOM layer of
  the
  pad
  Net bottom layer
  9.Geometry: The geometry of the pad
  10.Shape: When the pad uses a shape made by yourself, it can be assigned to the selected shape
  11.Flash: The negative layer can specify the Flash file corresponding to the drill hole. Generally, Regular pads do not care , In Thermal Relief, you need to specify
  12.width: the width of the pad
  13.Height: the height of the pad
  14.Anti Pad: anti-pad

• To give an example, a randomly drawn pad is drawn for distinction, not for engineering applications.