Wireless version guide of laser cutting tutorial (click to jump)
Advantages compared to the wireless version:
- You can quickly know whether the drawing frame is inside the board.
- There is no need to repeatedly locate the origin of the laser head.
1. Import file
First save the file format to be cut as .dxf
, copy it to the computer on the laser cutting side, and then double-click to open it directly on the computer
2. The result after opening is shown in the figure
3. Adjust the drawing position
Select all the drawings and then move (just move a little bit), try not to touch the edge
4. Select priority
Select the outer frame, right-click 2 in the upper right corner (that is, the blue area), and select Apply to this layer in the options that appear, and the outer frame will turn blue. Purpose
: Let the machine cut the inside first, and then cut the outer frame ( If there is no outer frame or you don’t need to consider the precision of the inner cutting, you can skip it)
5. Turn on the machine
Turn on all switches (3 sockets, 3 machines)
6. Plug in the printer data cable
It is this kind of cable, one end is plugged into the computer, and the other end is plugged into the machine.
7. Simulate cutting
Press start/pause to see if the simulated cutting effect is the same as the drawing, and you 走边框
can quickly see if there is a problem with the cutting.
8. Start cutting
If there is no problem, firstClose the lid! ! !, turn on the laser switch button and press it 雕刻输出
.
9. Finished cutting
Turn off the laser switch button first! ! !, then open the lid
Cut off the power
Problems that may arise
1. There is no way to open dxf on the computer
Solution: plug in this U disk
Wireless version guide of laser cutting tutorial (click to jump)
The above is just personal experience