BQ40Z50RSMR is a single-chip fully integrated solution based on battery packs. It provides a series of rich functions such as power monitoring, protection and authentication for 1-cell, 2-cell, 3-cell and 4-cell lithium-ion or lithium-polymer battery packs in series.
The BQ40Z50 device utilizes its integrated high-performance analog peripherals to measure usable capacity, voltage, current, temperature, and other key parameters of Li-ion or Li-polymer batteries, keep accurate data records, and communicate these The information is reported to the system host controller.
Function: Multi-function controller
Battery chemistry: Li-ion/Polymer
Number of batteries: 1 ~ 4
Fault protection: Over-current, over-temperature, over/under-voltage, short-circuit
Interface: SMBus
Operating temperature: -40°C ~ 85°C (TA)
Mounting Type: Surface Mount
Package/Case: 32-VFQFN Exposed Pad
Supplier Device Package: 32-VQFN (4x4)
Base Part Number: BQ40Z50
The ADS131B02QPWRQ1 is a two-channel simultaneous sampling 24-bit delta-sigma (ΔΣ) ADC. The ADC's wide dynamic range, low power consumption, and buffered analog input make it ideal for use in automotive battery management systems (BMS). The ADC input can be connected directly to a shunt resistor (for bidirectional battery current measurement), a resistive divider network (for high voltage measurement), or a temperature sensor such as a thermistor or an analog output temperature sensor.
Bits: 24
Sample Rate (per second): 32k
Number of Inputs: 2
Input Type: Differential
Data Interface: Serial, SPI
Configuration: ADC
Ratio - S/H: ADC: 0: 2
Number of A/D Converters: 2
Architecture : Delta Sigma
Reference Type: Internal
Voltage-Power Supply, Analog: 2.7V ~ 3.6V
Voltage-Power Supply, Digital: 2.7V ~ 3.6V
Features: Simultaneous Sampling
Operating Temperature: -40°C ~ 125°C
Package/Case: 20- TSSOP
Mounting Type: Surface Mount Type
The ISO7231CQDWRQ1 is a three-channel digital isolator, each with multi-channel configuration and output enable function. These devices have logic input and output buffers separated by TI's silicon dioxide (SiO2) isolation barrier. Used with isolated power supplies, these devices block high voltages, isolate grounds, and prevent noise currents on data buses or other circuits from entering the local ground and interfering with or damaging sensitive circuitry.
Technology: Capacitive Coupling
Type: Universal
Isolated Power: No
Number of Channels: 3
Input - Side 1 / Side 2: 2/1
Channel Type: Unidirectional
Voltage - Isolation: 4000Vpk
Common Mode Transient Immunity (Min): 25kV/μs
Data Rate: 25Mbps
Propagation Delay tpLH/tpHL (Max): 45ns, 45ns
Pulse Width Distortion (Max): 5ns
Rise/Fall Time (Typ): 2ns, 2ns
Voltage-Power Supply: 3.15V ~ 5.5V
Operation Temperature: -40°C ~ 125°C
Mounting Type: Surface Mount Package
/Case: 16-SOIC (0.295", 7.50mm Width)
Basic Product Number: ISO7231