Cognex smart camera IS2000 and Mitsubishi PLC adopt MC protocol communication setting detailed steps and case explanation

1. The settings of IS2000 (SLMP scanning interface) are as follows:
Controller type: PLC model IP address: PLC address Host port: PLC communication port in hexadecimal PLC setting, offset and number of devices can be changed. 3. Open the GX WORKS software, select a new project, click "OK", the interface is as follows: 4. Click "Connection Target", and then double-click Connection: 5. The connection target settings are as follows, click "Programmable Controller Direct Connection Settings", a pop-up As shown in the small picture below, select the communication method between PC and PLC (in this example, choose Ethernet):