When you have recorded a lot of test scripts with QTP, and you prefer that when you get off work, these scripts can be run automatically at a certain time, and can be run iteratively! In fact, it is not difficult at all to realize the above idea. At this time, we only need to use a tool to fully realize the above idea. So now I will introduce MTM (Multi Test Manager) grandly to everyone. Your job now is to download the latest version of it from the Internet, and then install it on your machine. After the installation is complete, start MTM, right-click in the blank of the program, and pop up "ADD SCRIPT", select the QTP script that has been recorded, and add it one by one according to the test cases you designed! If you want to set the tool further, then click "File" - "Preference", in the Run tab, you can set when the test you designed is used to run and how many iterations! And in the "Report" tab, you can set the configuration information for the resulting report when finished! At the same time, you can send you an Email when the "mail" tab is set up! (pretty nice feature)
Note: 1. Your QTP must be set well, do not pop up any active prompt page, otherwise your iteration will not be able to proceed smoothly
2. After setting the parameters in the Preference, don't forget to click "run batch" on the toolbar, and also pay attention to open QTP there, so that the MTM will not appear "unable to launch QTP" Tip 1
http://blog.csdn.net/flm2003/article/details/4427887