Pro/E product design hole command application tutorial
Using the hole command, you can create holes on the surface of the part simply and quickly. Next, let's look at its specific operation method
1: As shown in the figure below, to make a hole on the right side, how to use the empty command to operate it
2: Click the hole command to enter the control panel and set the type of hole to be created: simple hole or standard hole, as well as hole size and depth.
3: Select the plane on the right as the surface where the hole is placed, then the preview of the hole can be seen
4: Drag one of the green points to the upper edge as a positioning reference, and then modify the size
5: Drag another green dot to the left side, use the left side as a positioning reference and modify the size
6: After setting all the settings, click OK to complete the operation
The above is the explanation of how to use the Pro/E hole command. There are very detailed explanations for each step. I hope it will be helpful to everyone, thank you!