Chocolate keyboard keycap safest method of removal effort

Links: d https://forum.51nb.com/thread-1803503-1-1.html

T440p last week knocked keyboard cup water and hung up! Fortunately, not much water, the keyboard itself prevent the ability of the water (the water is absorbed by the keyboard), plus the roll cage blocked off, following impermeable to water.
In fact, early on shine dissatisfied with the keyboard, could not find a reason to change, this is just great, Ma bought a home emergency 95 new put. disassembly simple, the process is not the table here simply to talk about the keyboard cap things

  keycaps demolition of the water district will not find when cleaning wipe demolition keycaps, because I did not use the machine usually very careful of the water, only seven lines split over the old keyboard keycaps, just the forums and Baidu circle only one answer spoke to "extract from the upper key cap" and not about to pull, because the following X-carriage up and down direction. I'll do the same method to do, well, a little harder to really be able to pull down, but to pull each one is bad !! under bad bad !! !!
   <ignore_js_op>                                                                                                                                                                                                                                                                                          <ignore_js_op>     
<ignore_js_op>
Caps plastic jaws carefully observed a moment, found very hard and brittle, almost no elasticity, very easy damage! X bracket under the Cap, with expected is very flexible, not easy to break.
how to do it? pictured above, you can find all the cards The following are the jaw fracture, upper jaw intact; recall, I am from the pull down, pull the lower jaw when the force alone, because hard and brittle, are snapping up!
And the Internet, said, because the direction is up and down the bracket, the lower jaw is not on, so only from the pull down, can not pull from both sides. This is only half right, the right way is, indeed from around pull on both sides, but not to pull the left and right sides of the middle, and to pull "the side where the claws", the red circle shown below
<ignore_js_op>
such pull down keycap intact, and extremely easy, pico the force to hear from the voice of the pull down one side, and then a pull, Cap automatic Danfei!
<ignore_js_op>  <ignore_js_op>

several illuminated keycaps should be noted, Fn key and normal key card as claw on the other lighted jaws next
<ignore_js_op>
<ignore_js_op>  <ignore_js_op>

several large key caps should also note, there are supported by steel beams, pull off the jaws, steel beams still attached keyboard
<ignore_js_op>  <ignore_js_op>

final pull at all!, in addition to a bad start will not pull a few, without a damage to the rear.
<ignore_js_op>

Guess you like

Origin www.cnblogs.com/victorfrost/p/12582049.html