The use of LyCORIS model in LoRA guide
I saw this model at Station C, and I liked it very much at a glance
After a few struggles I finally managed to install
Next, let's start the installation and use together!
1. According to the prompt of the original boss, two plug-ins need to be installed
https://github.com/KohakuBlueleaf/a1111-sd-webui-locon
https://github.com/kohya-ss/sd-webui-additional-networks
The source blogger model is here, take it if you need it!
Model Weights: World in Miniature
After the installation is successful, you will see an interface like this
Add-on for Additional Networks
Check him as Enable, add your LyCORIS model at the Model, and adjust the weight.
2. Training
For training, I use another model here, Rev Animated. The effect of this model is really good, and the pictures are very delicate. It is recommended that everyone have a copy!
This is my configuration
The final drawing is as follows
It's amazing! ! ! A mini world in a water glass!
3. Some suggestions
- Don't render too large a picture, it will be very time-consuming
- Upsampling using ESRGAN 4x+
- Model Weight: The miniature world uses this weight