1. Make sure the bridge is connected to a local virtual machine network adapter:
Open the Control Panel \ Network and Internet \-Fi
Click on the network have a network connection property
To see if there are bridge protocol, if not, you can install it
In this step, you can see at the same time with the network card
2. Edit the virtual machine's virtual network
Vmware top left of the menu bar to open, edit / Virtual Network Editor
VMnet0 refers to the virtual bridge
VMnet1指host-only
VMnet8 refers to NAT
Click the bottom right to change settings
Select below the bridge mode, bridged to the NIC we just saw.
3. Modify the network card configuration file, set a static ip
1. The host now found in the machine using the ipconfig command ip and subnet mask, default gateway
2. modify the configuration file in a virtual machine
cd /etc/sysconfig/network-scripts
Modified with ifcfg-eno16777736 vi editor
Added at the end of a network and the local ip ip address, subnet mask, and
Then BOOTPROTO by the dhcp amended as static
3./etc/sysconfig/network modify the network configuration file
= NETWORKING Yes
the GATEWAY = # 172.23.0.1 to the machine and the same external network default gateway
4. Restart network
service network restart
Show ip address has been