Raspberry Pi achieve remote monitoring

surroundings:

  • Hardware: three generations of Raspberry Pi Type B, 5MP Camera Board Module
  • Software: Raspbian
  • Install Raspberry Pi camera module 1, to find CSI Interface (CSI interfaces alongside Ethernet interface), setting off a dark tape. 2, the interface CSI pull flap. 3, pick up your camera modules, will be attached to the protective plastic film on the lens tear. PCB to ensure that the yellow part (one side there is the word) is installed perfectly (you can gently press the yellow part to ensure perfect installation). 4, the cable insertion CSI interfaces. Remember, the blue side of the tape should be facing the direction of the Ethernet interface. Also, at this time also confirm cable installed after the bezel down.

  • Enabling camera modules raspberries come in after the installation of the camera module, first make sure you have upgraded the Raspberry Pi system and apply the latest firmware. You can enter the following command to operate:
  • $ sudo apt-get update $ sudo apt-get upgrade 
  • Raspberry Pi running the configuration tool to activate the camera module:
  • $ sudo raspi-config

     
 

  • Raspberries come in and run the server installation vlc
  •   $ Sudo apt-get install vlc $ sudo raspivid -o - -t 0 -w 640 -h 360 -fps 25 | cvlc -vvv stream: /// dev / stdin -sout '#standard {access = http, mux = ts , dst =: 8090} ': demux = h264 at the computer end, whether it is Windows, Linux or OSX, or Android machine, as long as the installation of VLC, you can now open VLC, and then open the media - "network streaming -" enter http : // IP address of PI: 8090 view real-time monitoring of network cards do not.

Guess you like

Origin www.cnblogs.com/lwlq/p/11546672.html