clover configurator finished version is a dedicated system for image mac boot configuration tool, you can effectively start to configure options, or start-up mode, and has a CPU, display and other settings options, with it you can create a more user-friendly of the guide or personalize it! This paper finishing an article on Clover Configurator for Mac FAQ, want to use the Clover Configurator for Mac to help you.
[dl]15-482[/dl]
Q: I received boot0: error or b1f: Error
A: One of the possible reasons is wrong partition file system. PBR sector boot1f32 need rather than FAT16 or FAT32 ExFAT. If you are unsure, it is recommended to use the command reformat the partition
Q: A 7_appears on the screen, nothing happens
A: This is the worst-case hardware incompatibility. Now it is no longer there. Only developers can help start the process by commissioning a small step. Unfortunately, the average user to do anything, except try to change BIOS settings or use the file boot7 instead of boot.
Q: The emergence of a similar BIOS interface, which has five options, "continue " to the top level.
A: This means that the file has been successfully loaded and started running, but can not find the file CloverX64.efi. Can not find the appropriate partition or the entire device. Explore options and try to identify the problem.
Q: Clover has been installed and started from a USB flash drive, but I can not see my hard drive.
A: For the Intel SATA driver earlier versions, the hard disk needs to be connected to the first SATA ports (SATA 0). In addition, it is understood that, despite the use of a good Chameleon, Chimera or XPC, but you want to try Clover without deleting them. It can be installed while the old boot loader and Clover, then the problem is solved. If you do not have a common SATA / SAS / RAID controller, try using boot7 file.
Q: I am using UEFI boot, but I do not see the Mac partition, only the traditional partition.
A: That's because you do not HFS + drivers are installed HFSPlus.efior the legal alternatives VBoxHFS.efi.