[Short-Circuit Constraint Violation] warning solution

Today encounter a problem with Altium Designer16 painting PCB when the DRC were detected, a warning is as follows:
[Short-Circuit Constraint Violation] GrayscaleSensor1.PcbDoc Advanced PCB Short-Circuit Constraint: the Between Pad D3 - 1 (54.314mm, 14.656mm) Multi ON -Layer and Pad D3-2 (51.774mm, 14.656mm ) on Multi-Layer Pads have the same JumperID: 1 but different Nets: NetD3_1 and GND 0:50:19 2019/7/28 17

mean my package Multi- Layer is a problem, you can also see a circle of white around the components D3, I will find the components of the package, point to go to find the problem, finally resolved, the solution is as follows:

this is the first pad, right, then look at the second pad:

problems found, Designator and Jumper ID is not the same as the Jumper ID into Designator just fine . After solving our update components, see the effect updated:

White did not, did not update the other components are still white. Note that we must make sure that the update is successful, I do not know if the software BUG, I want this component into a second land element, the element of choice after the changes before the update was successful.