Today weekend, under the previous things in order, do not talk nonsense, that is entered.
After about installing delphi control, and if we must re-install or reinstall delphi system, a lot of control to install in a Fana (except version is installed, you can just NEXT NEXT). I usually put IDE disks are installed on the system, in fact, the system is broken, not much better IDE, Delphi we installed in the system tray (I installed Delphi Xe).
Open Delphi, select Tools-> in the Options menu, select Library option, as FIG.
We modify the following Package output directory and the output path DCP output directory. Presumably these two know it, our output to the specified path, this is done to facilitate our management, re-install the control time before we can delete a clean version, otherwise there will be a lot of inexplicable mistakes do not know. In short the benefits of doing so is to facilitate our own management.
Output path and then we will be able to install the control, and pay attention to what the control, use it to clear the entire output path output path ide settings.
After the control is installed, as long as we back up under the registry, under the later time to re-install the system, we import it.
XE is the path
Put this back out.
Premise: 1, delphi 2 installation path has not changed, the controls put path has not changed, bpl path has not changed.
So on the Ok.
Reproduced in: https: //my.oschina.net/cookblack/blog/621377