Generally speaking, the drawing standard is the upper and lower layers of the signal layer, the VCC layer, the GND layer, and the VCC and GND layers are added in the stack manager.
Add a frame to add ordinary lines in the keep out layer
After drawing, click the line, and then click tab to select all.
Then click on the shape of the board in the design and select it to cut according to the definition of the selected object.
CTRL+M can measure the length Q key can switch between mil and mm
Add teardrops before laying copper
The line width is generally changed to 16mil, the maximum is 100mil, the general signal line is 16mil, the vcc is about 60mil, and the best motor is 40-50mil.
If components overlap, they must be in the rules
Uncheck it here.
Notes on pads:
When installing the component library, you need to put the component library in LIBI in the AD file location
Modify the name of the pin in the schematic diagram
in the pin name