Article directory
foreword
The pagoda panel installed in VMware yesterday can only be accessed from the intranet in the virtual machine, and the local (Windows) computer cannot access the pagoda panel, which is very uncomfortable to use
-
Pagoda panel installation tutorial: VMwork virtual machine installation pagoda-newcomer basic version tutorial (super detailed)
-
Common problems after the installation of the pagoda panel: centos pagoda panel installation and common error handling (super detailed) The address of the centos intranet panel cannot be opened
details
Install
-
After the pagoda is installed, the displayed information is as follows:
-
If you didn't write it down at that time, you can use the following command to view it
bt default
virtual machine access
-
Access the intranet panel in the virtual machine
-
Virtual machine access to the external network panel
local computer access
-
Access the extranet panel
-
Access the intranet panel
resolution process
The most commonly seen method on the Internet is the firewall port problem
- turn off firewall
- Pagoda panel port: 8888 open (now the port is 18890)
- The virtual machine network mode is changed to bridge mode, and some say it is NAT mode
- Enter the intranet address to access: Install the pagoda panel on the local VMware virtual machine_The pagoda installed on the local virtual machine is not 8888
- ……
Linux firewall related commands: Firewall under Linux_linux firewall
In the end, there was really no other way, when I saw such words when I was about to give up, I saw hope again
If you cannot access the panel, please check whether the firewall/security group has allowed the port [18890] of the panel.
Since the self-signed certificate of the panel has been enabled, the access panel will prompt that the certificate does not match. Please refer to the following link to configure the certificate
https://www.bt.cn /bbs/thread-105443-1-1.html
official tutorial
[Tutorial Post] How to enable panel SSL and set the browser to trust self-signed certificates : Pagoda SSL certificate configuration
Since it is configured in a Linux browser, it is not convenient to take screenshots, only the important ones are left, and the others are consistent with the official tutorial
-
download certificate
-
Paste the downloaded certificate locally
-
Install the certificate (double click to open)
-
The following operations can be done according to the official tutorial
Note :
- The required passwords are all certificate passwords
- After installation, you need to close the browser and restart
test
-
Local access to the extranet panel
Not surprisingly, or not
-
Local access to intranet panel
Successfully accessed the Pagoda panel
On Windows, you can access the pagoda panel in the virtual machine through the address of the intranet panel, which is much more comfortable than using it in the virtual machine