Learning to drive
From last year 's 2017.11 registration to learn to drive, to this year's 2018 , it's almost May 1st, and I'm still on the way to the third grade (last year, the third grade hung up once o( ╥﹏╥ )o ).
Record the experience of three learning to drive ( 2018.4.22 ) :
1. Lighting
1) When it comes to meeting cars, they are all low beams
2) When it comes to junctions, except for going straight through the junction at night (without any other modifications), the low beam is used, and the others are used alternately between high and low beams.
3) When passing through special places such as arch bridges, detours, crosswalks at night, or overtaking, the high and low beams must be used alternately.
4) When the lighting is good at night, or if you follow the car in the same direction, you must use the low beam
Note: Don't be nervous, listen to the question before doing the action, there is a 5s operation time. When listening to the next command, remember to restore the other lights except the low beam in the previous group.
- road test
1) Before starting, check whether the lights are restored, neutral, handbrake, instrument lights, and turn on the starting lights when starting.
2) Remember to hear clearly whether you are turning left or right and don't go in the wrong direction.
3) Change lanes, turn left or right, turn around, pull over, and turn on the lights in advance. Turn the steering wheel to change lanes after 3 seconds of turning on the lights . If the action is complete, it will automatically return to the light, remember to fill the light.
4) When crossing intersections, crosswalks, bus stop signs, and school intersections, you must step on the brakes at a distance of 3-5 meters, and observe left and right after stepping on. Turning must be <= 2 gears, and the crossing speed cannot exceed 30 yards
5) End the examiner, before getting off the car, neutral, handbrake, turn off the lights, and turn off the engine. Observe the car coming from the rear left, and must go out within 15 seconds after opening the door, and close the door tightly.