What should you do if the pointer jumps, moves unexpectedly, or reacts unstable when you use an input device with a touch surface. Don't worry, I will share with you the solutions today, I hope it will help you~
Try the following tips to solve the problem:
Check the device’s power supply to
make sure the device’s battery is fully charged. If you are using the Magic Trackpad 2 or Magic Mouse 2 mouse, make sure that its rechargeable battery is fully charged.
Avoid accidentally touching the surface multiple times.
Ensure that only a part of the finger is used to touch the touch surface, and the wrist is not pressed against the surface or too close to the surface. The touch surface may interpret this as your finger touching it and moving the pointer in that direction.
Keeping the touch surface dry and clean
can also cause this problem. Using a cloth or paper towel to wipe the surface of the touchpad or mouse can usually solve this problem.
If putting a piece of paper between your finger and the touch surface can solve the problem, consider buying a Teflon film to stick on the surface to avoid direct contact with moisture on the touch surface. Before installing the Teflon film, please make sure that the touch surface is clean and dry.
Note that grease or emulsion can also cause the same problem. You can use a clean, lint-free cloth dampened with water to clean the touch surface of the device.
Taking off the jewelry
When you use a device with a touch surface, jewelry may also cause interference. Try to remove the ring or bracelet to see if the jumping or abnormal behavior disappears.
Check the power adapter
that your Mac is using . This may happen if you are using a power adapter manufactured by a third-party company.
If you are using any of these power adapters, please unplug it and run your Mac on battery power to see if the pointer behaves correctly. If the device behaves normally when running on battery power, there may be a problem with the power adapter.
Avoid wireless interference
If there is wireless interference, the response of the Bluetooth device may be unstable.
Start your Mac in safe mode
If none of the above methods solve the problem, you can start in safe mode to determine whether the problem is caused by third-party software.
The above is the solution that Xiaobian brings to you when the pointer jumps when using the trackpad or Apple mouse on the Mac. If you want to learn more about mac, then pay attention to macz.com!