First, we need to understand the procedures sticky keys, the keyboard is our continuous input five times the shift key will trigger the Sticky Keys after the program,
And some are not logged in the system when the same operation will trigger it, so we can put the cmd
Sticky Keys program name into the name of the program , we continuously press the shift key five times you can not call cmd while signed yet,
You can then change the password using the command cmd ( cmd command: net user username password . Just click on it to change the format of the input password),
So the question is, since it has been forgotten your password, we can not log in to change the name, how to do it, then proceed as follows to complete the renamed.
Second, the steps of:
1. Figure Forgot your password does not go in, press the shift key five times would call out the sticky keys (if the call could not explain the vulnerability has been fixed, do not read below).
2. then shut down, i.e. following screen appears when going opening again when rapid shutdown (remove the plug between desktop and notebook off press the power button)
3. then boot, then the following interface will appear, select the start Startup Repair (recommended) , and then press Enter
4. When the following screen appears next, we want to tens of seconds or a few minutes of waiting
Will 5. After a pop, do not × out details Click here to question
6. Then we have the problem of information designated to the bottom, we will see the following message, click on the .txt file name suffix
7. Then there will be a notebook, then we will click on the top left of the notebook to open the file, find the directory where our Sticky keys: c: \ windows \ system32 \ sethc.exe
The program name to any name sticky key as: sethc-bak.exe;
8. cmd program and then find a copy cmd program out (make sure the folder inside there is also a program called cmd),
Then copy out copies were renamed, sticky keys instead of the program name: sethc , then click Cancel to restart the computer
9. The following interface to restart the computer after finished you can press the shift key five times to enter cmd to change the password, and then log on to fork out
Note: This tutorial is a network of the knowledge, only for them to learn from reference, if infringement private deleted!
What is the problem send me mail contact me: [email protected];