Benpian only for the extension of the bears on the error code: red strobe breathing, has made it clear it is determined that the code error is set.
[Anonymous] UAV remote firmware upgrade Chinese version _FS-i6S
table of Contents
4, the receiver mode setting S.BUS
5, the remote controller setting mode S.Bus
6, the flight control parameter setting mode S.BUS
1, the remote control type
Model: FS-i6S, those anonymous extension of the air with remote control;
2, receiver model
Model: FS-A8S, empty anonymous extension with by those who left the red circle is the code key, the right red circle is the interface;
Interface is a four-pin, and the extension wiring is empty by three holes, connected to GND side.
3, the process of the code
- Click on: Settings icon, is that wrench symbol;
- Click: system (system);
- Click: RX Bind (the code), the code of the remote control to enter a state .....
- A receiver with a toothpick on the code by pressing keys, the receiver power supply is turned on, the key can open the code;
- Then the receiver indicator has two states, red flashing: The code; Flashing red slowly: the completion of the code; the code process is very fast, you may not see the flash, it has successfully entered slow flash;
- Slow red flashing the receiver, the remote controller manually exit the unverified state, when the red light receiver, the code represents the completion;
- UAV power restart, remote reboot, the receiver indicator light indicates success of the code, try to hit the character unlocking UAV;
- If unsuccessful, the following operation continues.
4, the receiver mode setting S.BUS
In the receiver power, bright red lit state, press the code key for two seconds to switch the reception mode.
- i-Bus modes: 1 second lights turn off, after flash twice, indicating that mode into the i-Bus
- S.Bus mode: lights flash twice, after one second off, that enter S.Bus mode (empty anonymous extension were to set this)
UAV power restart, restart the remote receiver the code indicator light indicates a successful attempt to unlock the UAV playing 8 characters;
Not as successful, continue with the following operation.
5, the remote controller setting mode S.Bus
- Click the settings icon
- Click System (System)
- Click Output Mode
- Select S.Bus, return
- UAV power restart, restart the remote receiver the code indicator light indicates a successful attempt to unlock the UAV playing 8 characters;
- Not as successful, continue with the following operation.
6, the flight control parameter setting mode S.BUS
- Open and codes corresponding version of the anonymous host computer (the same information in the package), must correspond to the version or communication protocol may be different;
- Andrews use line is connected to a computer by an empty extension, connected to the host computer using HID Open
- After opening the connection will be displayed constantly received data, the left ring as shown below
- Note that, in the middle of the red circle error rate, 100% if this is the case, described flight control code version and not on the host computer, because they do not agreement between the data, to replace the corresponding PC version code version according to the same PC in the data packet will be no problem. Normal error rate is: 0.00%, it may be the next step.
- Open flight control data (paper airplane icons), click on the read parameters , check number 71 is (RCINMODE) parameter value, if the value is not S.Bus, S.Bus reset, the write parameter .
- UAV disconnect the power on again, reconnecting the host computer, read by the step flight control parameter value is checked whether the number 71 S.Bus,
- After success of the code, and the remote control flying normal communication, flight control is no longer red.
- UAV power-up, power on the remote control, try to hit a pigeon unlocked.
