串口-网线 连接交换机上的console端口
波特率9600
连接成功后，便可以操作
查看网络接口
[Quidway]dis interface Ethernet brief
*down: administratively down
(b): BFD down
#down: EFM Fault
(l): loopback
InUti/OutUti: input utility/output utility
Interface Physical Auto-Neg Duplex Bandwidth InUti OutUti
Ethernet0/0/1 down enable half 10M 0% 0%
Ethernet0/0/2 up enable half 100M 0.01% 0%
Ethernet0/0/3 down enable half 10M 0% 0%
Ethernet0/0/4 down enable half 10M 0% 0%
Ethernet0/0/5 down enable half 10M 0% 0%
Ethernet0/0/6 down enable half 10M 0% 0%
Ethernet0/0/7 down enable half 10M 0% 0%
Ethernet0/0/8 down enable half 10M 0% 0%
GigabitEthernet0/0/1 down enable half 10M 0% 0%
查看聚合
[Quidway]display eth-trunk
Eth-Trunk1's state information is:
WorkingMode: NORMAL Hash arithmetic: According to MAC
Least Active-linknumber: 1 Max Bandwidth-affected-linknumber: 8
Operate status: up Number Of Up Port In Trunk: 1
--------------------------------------------------------------------------------
PortName Status Weight
Ethernet0/0/1 Down 1
Ethernet0/0/2 Up 1
Ethernet0/0/3 Down 1
Ethernet0/0/4 Down 1
新建聚合
<Quidway>system-view
Enter system view, return user view with Ctrl+Z.
[Quidway]interface eth-trunk 1
添加端口
[Quidway]int Ethernet0/0/2
[Quidway-Ethernet0/0/2]dis th
#
interface Ethernet0/0/2
port default vlan 1
ntdp enable
ndp enable
#
return
[Quidway-Ethernet0/0/2]undo port default vlan
[Quidway-Ethernet0/0/2]
Jan 1 2008 00:31:04 Quidway %%01IFNET/4/IF_STATE(l): Interface Vlanif1 has turned into DOWN state.
[Quidway-Ethernet0/0/2]undo ntdp enable
[Quidway-Ethernet0/0/2]undo ndp enable
[Quidway-Ethernet0/0/2]
[Quidway-Ethernet0/0/2]eth-tr
[Quidway-Ethernet0/0/2]eth-trunk 1
Jan 1 2008 00:31:26 Quidway %%01TRUNK/4/TRUNKUP(l): Interface Eth-Trunk1 turns into UP state.
[Quidway-Ethernet0/0/2]
[Quidway-Ethernet0/0/2]quit
提示：要清除原有配置，不然会有Error: The port has configurations. Please clear them first.错误
依次添加想要添加的端口
配置完成后 ctrl+z 退出 system-view
save保存配置