Article directory
Preface
With the popularization of smart electric vehicles, the application of in-vehicle Ethernet has gradually become more widespread. Therefore, during the automotive electronics bench test, it is inevitable to simulate and send Ethernet messages. This article introduces two methods to simulate and send Ethernet ARP messages.
1. Environment setup
CANoe installs
VN5650 (any device supported by Vector that supports ETH can be used)
2. IG generator simulates ARP messages
1. Create a new IG module in CANoe:
2. Start the IG generator: CANoe->Simulation->Packet Builder, follow the prompts to set:
3. Add an Ethernet package to the IG module and set it as an ARP protocol package: