In some multimedia conference room, in order to achieve more clear, the effect of large-screen display, will choose to replace the original mosaic screen LCD projector, as we all know, LCD splicing screen resolution can reach 1920 * 1080 or more, the multi-block splicing 4K display function can be achieved, so that you can achieve high-definition display, which is very important for indoor viewing experience for the conference room, so we want to build a LCD screen splicing meeting what issues need to consider it?
First, consider the choice of the screen size. Through the liquid crystal splicing units of any size of the display screen of the core of the conference room, and so we want The long room installation position, wide design corresponding display area, and then decide how many blocks in accordance with the display area, the number of dimensions of the liquid crystal multi-screen. Because of different sizes out of the LCD screen splicing composition different sizes, such as 55-inch LCD screen splicing length than the 46-inch width of 20 centimeters, the use of different sized mosaic screen LCD, the number of its use is certainly not the same. 
Second, we must consider the choice of patchwork. In the future we choose a good size and the number of LCD splicing screen, taking into account the overall effect of the show, we have to choose which to use patchwork, patchwork because the width determines the effect of the whole mosaic display, the smaller patchwork, natural display the better the effect, the current mainstream patchwork have 3.5mm, 1.8mm, 1.7mm, 0.88mm, etc., can be e-Carpenter on the map is to Qingyuan City, Guangdong departments and units to create a patchwork of 0.88mm LCD splicing screen, use super Narrow LCD splicing screen will give us a better viewing experience.
Finally, taking into account the installation of LCD screen splicing. Because it is in the conference room, so take up less space as much as possible. If a solid wall, the wall the way we can direct wall-mounted so occupied space is minimal, if the latter is to facilitate maintenance, maintenance mounting bracket can be installed before, when the liquid crystal mosaic dismiss the problem needs to be replaced without removing it around screen. If not backdrop solid wall, the stent may be welded using, for Guaping from the roof to a floor stand bracket, the release force point to the ground, in order to reduce the pressure wall. After splicing the liquid crystal panel is installed, we can screen hemming decoration, for wrapping around the screen or a sound absorbing panel using a material such as aluminum plate, but when the decoration must be according to the requirements of the art, a suitable reserve the distance to the edge of the screen, the screen body to prevent a collision to cause damage to the screen and the like.
In general, the signal source conference room are usually computers, but some occasions only one computer input, but some conference rooms required more than one computer input, if only one computer signal input, we can with a distribution device can, which can display full screen, we only need a computer through a network cable connected to the distributor, then the HDMI cable to the dispenser and the liquid crystal screen is connected to the large-screen display. If the signal is more than one computer, then you can use the switching matrix assignment signal, for example, we have four computer display screen needs a total of 12 NTU screen, then only need to be equipped with a 4 to 12 into HDMI matrix can be.
Essentially create a conference room LCD screen splicing main consideration is the source signal and large screen, several control device, in order to achieve additional functions may also be more specific with the appropriate software and hardware, such as video conferencing, a touch function, audio, etc. these can be individually configured in accordance with specific needs.
Articles by Shenzhen maker Electronic publishing order, please indicate the source!